Arthur Holm launches Dynamic at ISE

Arthur Holm will launch its Dynamic range at the ISE show, highlighting new features that permit control and remote diagnosis of monitors.

The system can detect obstructions that may block the screen movement, with the capability to stop immediately.

It has three isolated inputs that can be programmed and standard functions are UP, DOWN and INPUT SELECT (VGA or DVI).

Furthermore it has an XLR-4 power connector with security lock, a port for future upgrades and an auto test system. Communication protocol is based on CAT-5. The whole range provides an RJ45 input and output connector so the screens can be looped with a maximum of 30 units per line. The software currently permits a run up to 200.

There is a rotative selector per screen to determine its ID.

Each Group of 30 monitors can be connected to a master module, through Ethernet or WI-FI router.

The Communication protocol can control:
- UP
- OFF/Monitor
- ON/Monitor
– Block of UP & DOWN buttons
– Input selection: DVI or VGA
- Failure alarm
– Mechanical block alarm
– Adjustment and maintenance functions

Article Categories

> >